Excellent JN0-362 Updated 2021 Dumps With 100% Exam Passing Guarantee
Best way to practice test for Juniper JN0-362
NEW QUESTION 36
You are configuring a default static route using the default preference value. You want to ensure that any static route that you configure in the future will be less preferred than the OSPF routes that are configured on the network.
Which command will accomplish this task?
- A. set routing-options static route <IP address> preference 9
- B. set protocols ospf preference 6
- C. set routing-options static defaults passive
- D. set routing-options static defaults preference 20
Answer: D
NEW QUESTION 37
Click the Exhibit button.
Referring to the exhibit what are two reasons for the configuration stanza? (Choose two.)
- A. to mark the tunnel down after the hold-time expires
- B. to mark the tunnel up after the hold-time expires
- C. to remove the tunnel interface from inet.0 after the hold-time expires
- D. to reduce the risk of forwarding traffic through a stateless tunnel
Answer: A,D
NEW QUESTION 38
Click the Exhibit button.
You have applied the policy shown in the exhibit to the forwarding table on an MX Series device. How is traffic load-balanced?
- A. per flow
- B. per segment
- C. per frame
- D. per packet
Answer: D
NEW QUESTION 39
What are three valid BGP message types? (Choose three.)
- A. Route
- B. Hello
- C. Keepalive
- D. Open
- E. Refresh
Answer: C,D,E
NEW QUESTION 40
What must be configured for all IBGP speakers in an AS to have consistent routing information?
- A. Static routes to the EBGP gateways
- B. Default routes to the IBGP gateways
- C. Full mesh of IBGP sessions between IBGP speakers
- D. Partial mesh of EBGP sessions between EBGP speakers
Answer: C
NEW QUESTION 41
Before configuring an RSVP LSP in your network, you first apply a baseline configuration to all of the routers.Which three configuration elements are minimally required in the baseline? (Choose three.)
- A. protocols mpls for the appropriate interfaces
- B. protocols rsvp for the appropriate interfaces
- C. protocols ldp for the appropriate interfaces
- D. family mpls on the transit interfaces
- E. family mpls on the loopback interface
Answer: A,B,D
NEW QUESTION 42
You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the locally connected CE router's interface. The address of the interface is 192.168.1.1; the VPN routing-instance is named VPN-A.Which command will accomplish this task?
- A. ping VPN-A 192.168.1.1
- B. ping vpn-instance VPN-A 192.168.1.1
- C. ping instance VPN-A 192.168.1.1
- D. ping mpls l3vpn VPN-A 192.168.1.1
- E. ping routing-instance VPN-A 192.168.1.1
Answer: E
NEW QUESTION 43
Click the Exhibit button.
Referring to the exhibit, if there is a connection failure between router1 and router2, how much time will pass before the devices declare the BFD session dead?
- A. 900 ms
- B. 300 ms
- C. 600 ms
- D. 1200 ms
Answer: A
NEW QUESTION 44
Click the Exhibit.
You are using OSPF as your IGP in your network.
You have applied the OSPF configuration shown in the exhibit to router R1.
Which statement is true in this scenario?
- A. Router R1 will send a default route to router R2.
- B. Router R1 must be configured as a stub area for Area 0.0.0.0.
- C. Router R2 will not have a route to subnet 172.16.4.0/24.
- D. Router R3 will not have a route to subnet 172.16.3.0/24.
Answer: D
NEW QUESTION 45
Click the Exhibit.
Referring to the exhibit, which statement is correct about MVRP?
- A. AS1 is not allowing ES2 access to VLAN 300.
- B. AS1's VLAN ID list is missing an entry for VLAN 300.
- C. ES1 is not advertising VLAN 300 to AS1.
- D. ES2 is not interested in VLAN 300.
Answer: D
NEW QUESTION 46
Which three statements are true about GRES? (Choose three.)
- A. GRES requires redundant REs.
- B. Control plane information is preserved.
- C. Interface information is preserved.
- D. Kernel information is preserved.
- E. GRES requires only one RE.
Answer: A,C,D
NEW QUESTION 47
Which configuration can be applied to ensure that no more than 600 MAC addresses are learned by a virtual switch?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: B
NEW QUESTION 48
Click the Exhibit button.
Referring to the exhibit, which statement about the IS-IS interface is true?
- A. The ge-0/0/0.0 interface will act as an L1/L2 interface
- B. The ge-0/0/0.0 interface will act as an L2 interface only
- C. The ge-0/0/0.0 interface will not be assigned to a level
- D. The ge-0/0/0.0 interface will act as an L1 interface only
Answer: A
NEW QUESTION 49
Which two fields of a hello packet must match on both routers when forming an OSPF adjacency? (Choose two.)
- A. Network mask
- B. Router priority
- C. Designated route
- D. Hello interval
Answer: A,D
NEW QUESTION 50
In which situation would you disable penultimate-hop popping?
- A. When you want to ensure the penultimate router can perform the destination route lookup
- B. When you want to utilize a penultimate router that supports IPv6 tunneling
- C. When you want to enforce the same class-of-service behavior through the entire LSP
- D. When you want to bypass a penultimate router that does not support IPv6 tunneling
Answer: C
NEW QUESTION 51
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. Interface ge-3/0/0.0 has a default metric of 10
- B. Interface ge-1/0/0.0 can only form a single adjacency
- C. Interface xe-0/0/0.0 has a default metric of 10
- D. Interface xe-0/0/0.0 can only form a single adjacency
Answer: B
NEW QUESTION 52
......
Service Provider Routing and Switching, Specialist (JNCIS-SP) Certification Sample Questions and Practice Exam: https://www.examboosts.com/Juniper/JN0-362-practice-exam-dumps.html