Latest JN0-362 Pass Guaranteed Exam Dumps Certification Sample Questions
New JN0-362 Test Materials & Valid JN0-362 Test Engine
NEW QUESTION 13
You are asked to design a Layer 2 VPN service between service provider networks that needs Ethernet transport capabilities. The VPN should support two or three endpoints. Which Layer 2 VPN technology should you propose?
- A. BGP Layer 2 VPN
- B. LDP Layer 2 circuit, using the RFC 4448 Layer 2 frame format
- C. LDP-signaled VPLS
- D. BGP-signaled VPLS, using the RFC 4448 Layer 2 frame format
Answer: D
NEW QUESTION 14
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. Routes from 10.3.3.3 are less preferred than the default local preference
- B. Routes from 10.1.1.1 are less preferred than routes from 10.2.2.2
- C. Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1
- D. Routes from 10.1.1.1 are less preferred than the default local preference
Answer: C
NEW QUESTION 15
You are asked to configure and apply a new routing policy to influence routing advertisements received from a specific EBGP peer.
In this scenario, which statement is true?
- A. The new policy should be applied as an import policy for the specific EBGP peer.
- B. The new policy should be applied as an export for the EBGP group in which the peer is defined.
- C. The new policy should be applied as an export policy for the specific EBGP peer.
- D. The new policy should be applied as an import policy for the EBGP group in which the peer is defined.
Answer: A
NEW QUESTION 16
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. Routes from 10.1.1.1 are more preferred than routes from 10.2.2.2
- B. Routes from 10.2.2.2 are less preferred than the default local preference
- C. Routes from 10.3.3.3 are more preferred than the default local preference
- D. Routes from 10.2.2.2 are less preferred than routes from 10.3.3.3
Answer: C
NEW QUESTION 17
Click the Exhibit button. What does IS-IS/18 mean in the output displayed in the exhibit?
- A. These routes are external Level 2 routes.
- B. These routes are internal Level 2 routes.
- C. These routes are external Level 1 routes.
- D. These routes are internal Level 1 routes.
Answer: B
NEW QUESTION 18
Which two statements are true about IP and GRE tunnels? (Choose two.)
- A. The TTL field is changed in the inner IP packet header
- B. The protocol field is changed in the inner IP packet header
- C. Tunnel endpoints need a valid route to the remote endpoint
- D. Tunnel traffic is encrypted
Answer: A,C
NEW QUESTION 19
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. R1 is an ABR
- B. R2 is an ASBR
- C. R1 is a backbone router
- D. R2 is an ABR
Answer: D
NEW QUESTION 20
Click the Exhibit button.
You are troubleshooting a new BGP peering session which is not establishing.
Referring to the exhibit, which statement is true?
- A. The neighbor does not support IPv6
- B. The update messages contain an unsupported option
- C. The peer's AS number is misconfigured
- D. The TCP session is not establishing
Answer: C
NEW QUESTION 21
Your customer complains that their Layer 3 VPN is not passing traffic from one site to another. You assigned that customer to VPN-A. Which command on the PE router will confirm the presence of customer routes?
- A. show route VPN-A
- B. show route VPN-A table bgp.l2vpn.0
- C. show route table VPN-A.inet.0
- D. show route table inet.3 VPN-A
Answer: C
NEW QUESTION 22
What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)
- A. Layer 2 logical interface
- B. Logical tunnel interface
- C. GRE tunnel interface
- D. Trunk interface
- E. Access interface
Answer: A,D,E
NEW QUESTION 23
Click the exhibit.
A customer has two VLANs to extend between Site-1 and Site-2. The customer does not want to route the VLANs or renumber the VLANs.
Referring to the exhibit, which two VLAN IDs are egressing the MX Series device towards the optical transport network after translation? (Choose two.)
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B,D
NEW QUESTION 24
Which three statements are true about the BGP community attribute? (Choose three.)
- A. Routing policies can be simplified using BGP communities.
- B. Only well-known communities can be passed between AS networks.
- C. There are three well-known communities.
- D. Communities can be used to signal local preference in other AS networks.
- E. Communities are used in the route selection process.
Answer: A,C,D
NEW QUESTION 25
Which statement correctly describes a characteristic of IPv6 unicast addressing?
- A. Link-local addresses are in the range of FE00::/12.
- B. Only one loopback address exists, ::1/128.
- C. Link-local addresses are in the range of FF00::/8.
- D. Global addresses are in the range of 2002::/16.
Answer: B
NEW QUESTION 26
You notice that the RID of your router is being taken from the address of your management interface.
What could cause this scenario?
- A. The loopback address was not configured under [edit protocols ospf].
- B. A suitable loopback address was not configured on the router.
- C. The loopback address was configured with a /32 address.
- D. The loopback address was configured under [edit routing-options].
Answer: B
NEW QUESTION 27
Click the Exhibit button.
Referring to the exhibit, if there is a connection failure between router1 and router2, how much time will pass before the devices declare the BFD session dead?
- A. 900 ms
- B. 300 ms
- C. 1200 ms
- D. 600 ms
Answer: A
NEW QUESTION 28
Click the Exhibit button.
Customer-1 wants the Service Provider to allow STP to operate normally on all ports but only allow the MX Series devices to manage the Layer 2 topology.
Referring to the exhibit, which feature needs to be implemented on all devices to accomplish this task?
- A. root protection
- B. loop protection
- C. MAC movement protection
- D. BPDU protection
Answer: B
NEW QUESTION 29
What must be configured for all IBGP speakers in an AS to have consistent routing information?
- A. Full mesh of IBGP sessions between IBGP speakers
- B. Default routes to the IBGP gateways
- C. Static routes to the EBGP gateways
- D. Partial mesh of EBGP sessions between EBGP speakers
Answer: A
NEW QUESTION 30
What are three label operations that an MPLS-enabled router performs? (Choose three.)
- A. rewrite
- B. push
- C. insert
- D. pop
- E. swap
Answer: B,D,E
NEW QUESTION 31
......
JN0-362 Sample with Accurate & Updated Questions: https://www.examboosts.com/Juniper/JN0-362-practice-exam-dumps.html